Locksmith Pego Old town · Monte Pego · Marjal · Orba Call 24h

Rain and damp

After the storm, a key that grinds in the lock

Heavy rain drives water into a cylinder that faces the weather. What happens inside, what to put in it, what never to put in it, and how to tell when it is past saving.

AEMET has kept a rain gauge in Pego since 1948. In July 2025, a month that normally brings under ten litres per square metre, it collected 131.2, the wettest July of the whole series. In the storm of 24 July, which soaked the whole Marina Alta, Pego’s gauge took in 90.2 litres. Five months later, in the 48 hours to the morning of 26 December, a station at les Verdales caught 162.3.

Rain like that does not only flood a street. It drives water sideways into anything that faces it, and a door cylinder is a small brass tube full of springs and pins with an open keyhole at one end.

What the water does inside

A cylinder works because five or six tiny pin stacks, each pushed down by a spring, line up when the right key is in. Water gets in through the keyway and sits there. In a dry week it evaporates. In a wet week, or in a house near the marjal where the air never quite dries, it stays, and three things happen:

  • dust and old oil that were already inside turn into a paste;
  • the springs, which are thin steel, start to rust and lose strength;
  • a pin that should drop freely sticks halfway.

The result is the key that goes in but turns roughly, or turns on the second try, or grinds as if there were sand inside. Sometimes there is: grit washed down a façade ends up in the keyway.

The first aid that works

  1. Dry it. Blow into the keyway, or use a hairdryer on a low setting for a minute. Do not heat it hard.
  2. Use a dry lubricant made for locks. Graphite powder or a PTFE spray, one short puff into the keyway.
  3. Work the key. In and out half a dozen times, turning it fully each way. Wipe the key between goes: whatever comes out on it is what was jamming the pins.
  4. Leave it a day, then try again.

What not to put in a lock

  • Cooking oil or a thick household oil. It feels smooth for a day, then traps every grain of dust that comes in.
  • A general water-displacing spray as a lubricant. Fine for driving water out once, but it dries to a film that does the cylinder no favours if used every week.
  • Force. If the key needs a pair of pliers to turn, it is about to snap, and a broken key in a wet cylinder is a much bigger job than a stiff one.

Signs it is past saving

If the key still grinds after the steps above and a few dry days, the cylinder is worn or corroded inside, and no spray will bring it back. Other signs: an orange or grey line on the face of the cylinder, a key that comes out darker than it went in, or a key that has started to twist.

Then the answer is a new cylinder. It is a short job on most doors, and if the door faces the weather it is worth choosing one with a keyway cover.

The doors that suffer most

Street doors inside the old walls, which open straight onto the street with nothing above them, and gates and doors of houses on the partidas, where the nearest roof may be a pump house, take the rain head on. The padlocks out there suffer even more; there is a separate page on the padlock on an irrigation pump house. And if the house is old, the doors inside the medieval walls have their own quirks.

Easier to explain it out loud?

Ring, or WhatsApp a photo of the door or the lock with a pin of where it is, and you will be told plainly what it needs.

Open 24 hours · 7 days

Call 24h WhatsApp (opens WhatsApp)