Booked lock work
Lock change Pego, for cylinders that grind after a wet season
A key that grinds, a lock that needs a shove before it turns, a cylinder that has never been changed. In Pego the culprit is often damp rather than age. Either way, it is booked for a day that suits you and done properly.
Open 24 hours · 7 days
- Cylinders, mortice and multipoint
- Keyed-alike sets on request
- Normal hours, by appointment
Why locks wear here
A wet valley is hard on a cylinder
Pego sits between the sierras and a marsh. The Marjal de Pego-Oliva is fed by the Bullent and the Racons and by springs from the aquifers under the hills, and the air rarely dries out completely.
Then there is the rain. AEMET has kept a gauge in Pego since 1948, and July 2025 brought 131.2 litres per square metre, against an average of 9.6 for the month. In December 2025, a gauge at les Verdales caught 162.3 litres in 48 hours. A cylinder on a door that faces the weather takes in water every time, and the small springs and pins inside start to rust.
Rain on the lock does not ruin it at once. It wears it by degrees: the key turns less smoothly each winter, until one morning it does not turn at all. What to do when a cylinder grinds after a storm covers the first aid.
Signs
When a lock is telling you it is time
- The key goes in, but only turns on the second or third try.
- You have to pull or push the door before the lock will throw.
- The key has a visible twist or a worn tip, or you have bent one already.
- There is a rusty line on the cylinder face, or the key comes out grey.
- A mortice lock clicks but the bolt does not go all the way.
- On a multipoint door, the handle has to be lifted hard before the key turns.
Any of these is a lock to deal with before it fails with you outside. If it already has, that is a matter for the page on opening doors.
What is fitted
Cylinders, mortice locks and multipoint mechanisms
Euro cylinders
The usual cylinder on most front doors. Swapped in minutes, in the right length for your door. Anti-snap and anti-bump versions are available; heavier protection after a forced entry is a matter for the page on repairs after a break-in.
Mortice locks
The lock set into the thickness of a wooden door, common in the older houses of the town. Repaired where it can be, replaced where it cannot, keeping the door as it is.
Multipoint locks
Several bolts along the edge, worked by the handle and the key. Usually it is not the lock but the alignment: a door that has dropped or swollen a few millimetres makes the bolts drag. That is adjusted before anything is replaced.
Padlocks on the partidas
The citrus of Pego is watered from wells, and every pump has a hut with a padlock that gets opened once a week or once a month. Those padlocks seize in the damp. Which kind lasts is explained in the advice on pump-house padlocks.
Not the same job
A stiff lock or a change of owner?
This page is for a home you already live in, whose locks are worn. If you have just bought the house, or moved in, the question is different: who else has keys? Then every outside lock is changed in one visit, and that has its own page for new owners.
The same visit covers the town and the villages listed on the coverage page. To book a day, the contact page sets out the best way to reach us for booked work.
Questions
Asked before a lock is changed
Should I spray oil into a lock that has gone stiff?
Not cooking oil and not a thick general-purpose oil: both hold on to dust and turn into a paste. A dry graphite or PTFE lubricant made for locks is the right thing, a short puff, then work the key a few times. If the lock is still stiff after that, it is worn or corroded inside, and lubricant will not bring it back.
Can only the cylinder be changed, or does the whole lock go?
On most doors only the cylinder, the part the key goes into, needs changing. It takes a few minutes and the lock body stays in the door. A mortice lock with tired springs or a multipoint mechanism that drags is a different job, and you are told which one your door needs before anything is ordered.
Can the new cylinder take the same key as the back door?
Yes. Cylinders can be supplied keyed alike, so one key opens the front door, the back door and the gate. It has to be planned before they are ordered, so mention it when you book.
Is this done at night too?
Not as a rule. Changing a worn lock is booked work, in normal hours, on a day that suits you. If the lock has failed and you cannot get in, that is a lockout, and it is dealt with at any hour.
What people need next
Often booked in the same visit
Advice pages that point here
Book a look at a lock that is going
Send a photo of the lock and of the edge of the door on WhatsApp, and you will be told whether it is a cylinder, a whole lock or just an adjustment.